EVGA 113-M2-E113-TR User's Guide download pdf (Page 23)

8-pin ATX 12V Power (PW12)

PW12, the 8-pin ATX 12V power connection, is used to provide power to the

CPU. Align the pins to the connector and press firmly until seated.

Connecting IDE Hard Disk Drives

The IDE connector supports Ultra ATA 133/100/66 IDE hard disk drives.

1. Connect the blue connector (the cable end with a single connector) to the

motherboard.

2. Connect the black connector (the cable with the two closely spaced black

and gray connectors) to the Ultra ATA master device.

3. Connect the gray connector to a slave device.

If you install two hard disk drives, you must configure the second drive as a

slave device by setting its jumper accordingly. Refer to the hard disk

documentation for the jumper settings.

If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are

attached to the same cable, the maximum transfer rate between the drives

may be reduced to that of the slowest drive.

GND

12V

5 8

Card-edge side

IDE Connector

Card-edge side

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 81 82

Chrisjar 10 Apr 2024 | 13:00:33

Hello, im noob :)

EVGA 113-M2-E113-TR User's Guide Page 23